Place the key into ignition then turn. it to the on position right before you full turn the engine on, when the key is in the on position hold down the unlock door button for 5seconds till you here two clicks after the first sounding primary click. keep holding after u hear the two clicks until you hear another click. after the third click turn car key to off. then turn back to on after 3second in off and all doors should open.
I would say just take the heart/drive out and bring it to a computer store that can transfer data to a portable drive...or buy these... http://m.staples.com/StarTech-8-3-USB-3-0-to-2-5-SATA-III-Hard-Drive-Adapter-Cable-W-UASP-SATA-to-USB3-0-Converter/product_IM1UN4218 http://m.staples.com/StarTech-1-5-LP4-Power-SAS-To-SATA-Data-Transfer-Cable-Red/product_2419331
Hi! When u first setup the Passport u were also directed to the WD passport online page go to that online page and put in your login info then look for you drivers password and change it which will reset it! Once done unplug the drive and replug in. It should then work because if you do as the previous suggestion fix it could wipe your drive or not allow you to acces that info on it while creating a new section
Here are the things u need and guide in how to do it! How to Install a 2.5-inch SSD in a 27-inch iMac Mid 2011 (Updated) OWC Complete Hard Drive Upgrade Kit Including Tools for all 27" iMacs 2011 The last is sold on Amazon! Good luck
You could try battery calibration reset?!! Use phone till it drains completely! When u place phone into charge hold down the on/off button and the home button as if u wish to enter DFU mode! While in that mode let it fully charge! After its fully charged hold down on/off to turn fully off the press on button let go of on button immediately and see when it turns on if it resetted the battery.
Hi Tammy, okay...I've seen the responses with all kinds of needless questions so I will make this really easy! 1/. Just plug in the HDMI plug you got from cable box to HDMI port to TV... Use the HDMI 1 port on TV please for this step. After you plugged in both sides of the HDMI to its proper places then plug in box electrical wire to get power! Before turning on cable box turn on the TV and use the remote to get to the setting of the TV where u can see which channel line u are needing to use to get reception feed which should be HDMI 1. Now once this is done turn on cable box... and wait till it goes through its setup! It would also be a good thing to make sure that the cable wire is in the right place for me its the back center of my box but for u it can be on the far left because there are two places on the xfinity box u can screw the cable two which could be the simple problem... as the TV and Box are both on try screwing on to either and give a few seconds for each to see if you get picture it should...
Hey Kenneth, you didn't have to reset just needed to delete any remotes in the settings. Of course changing internet network name is never a good thing to do... But !&&* when all else fails button pushing helps!!! Just try not doing that again! If u need future help feel free to ask I do not stop searching or fixing until I can give the right answer!!!