General computer and small device repair shop. Data...
Hey I’ve got a 12.9 and tried replacing the screen and found that the replacements ribbon wiring was different? Do I need to get a sepecif version to get the right screen or ?
Middle left, look at the 2 connecting ribbon wires as what I’m looking at in my hand is that ones L shaped with the 2 ports male and the cracked screen has different pins and in not seating properly?
Hello there OK so I have 2 screens with 2 different connectors one L shaped (which is on the new screen) and the old cracked screen has a rectangular type? I’m not sure rather it’s a 1gen/2nd gen type of problem? I’m about to grab my hot air gun to completely disassemble the cracked screen, as maybe I’m missing something? Any assistance is welcome… well actually please help me with this before I get a headache since this has totally frustrated me and i’ve had this sitting for nearly 2 1/2 months now but it’s about that time that I readdress this in attempt to fix it.
During take off 1 motor doesn't accelerate evenly with the rest resulting in a sideways gangster lean, so it just gos into a wall. Wires seem fine, motor works , might have sensors to determine hight not sure what should I look for to help me diagnosis problem. Ty
Yes, have you paired the device with your controller, usually on these you turn both on, while it's blinking, go to controller and motion the speed stick all the way up and all the way down in that order, and they'll probably beep at u, and the lights will still now your paired and try moving the controls now.
*Note* Always read your user manual, it's there to tell you what's what and how and all that fun stuff, like features built in that you might not have known existed, especially in drones. Hope this helped
Check the motor for that specific blade
1. If it doesn't make any sound or even trys to move it may not be receiving power due to a severed wire, solution would be reconnect wire, or solder new in.
2. If it's black or smells burnt it could have fried motor solution, new motor
3. Could have bent the spinning components in motor and it could be locked in place. Solution replace motor.
These are simple problem discoveries may help you.
I'm not a drone expert, but I know a little. Some devices (like a cellphone) have calibration and placement components, and what these do is help determine where said device is facing and calibrate the angle for whatever purpose it's told to. So like a cellphone that is turned sideways, the phones picture rotates to suit the angle it's tilted in, flip the phone and the sensors and calibration say "hey phone your upside down" and the phone rotates these image.
Well drones are made by God only knows how many companies, and everyone likes to do it there way and add features that others might not (what I'm saying here is they're all just learning with us because, It's not completely defined what's good or bad/ useful or useless)
So with all that I came up with my reasoning that this is your problem, I could be completely wrong, **So this is an educated guess.**
Your drone has a sensor or something like it and it's stuck in place, or has a bad connection in a leg. Sorry I'm out of space, good luck, websrch it