这个拆解是不是维修指南。 要维修你的的turbidity,请使用我们的服务手册

  1. first thing  u want to do is take out the two screws on each side of the meter and also take out  all the screws on the bottom  you will need a philips head  screw driver
    • first thing u want to do is take out the two screws on each side of the meter and also take out all the screws on the bottom you will need a philips head screw driver

    添加评论

  2. Now unscrew the 4 screws on the face plate  and  you will be able to lift the cover  off  the meter  but be carful as there are a few plugs and screws  left  for you to remove
    • Now unscrew the 4 screws on the face plate and you will be able to lift the cover off the meter but be carful as there are a few plugs and screws left for you to remove

    添加评论

  3. 订单满 $20 免运费
    结账时使用优惠码 BLUEANDBLACK
    订单满 $20 免运费
    使用优惠码 BLUEANDBLACK
    • Unplug the three prong plug and unscrew and pull out all the wires off the terminal block now you are able to take the cover completely off> the terminal block is basically a neat way of distributing power

    • NOTE: mark where each wire goes on the terminal block for easy re installation

    添加评论

    • Unscrew all the nuts shown using an adjustable wrench to remove circuit board

    添加评论

    • tilt the bulb so screw access is available as shown then slide bulb canister off telescopic shaft

    添加评论

    • tools used : philips head screwdriver flat head screwdriver adjustable wrench

    添加评论

maxwell

于2018年04月19日注册

142 信誉积分

撰写一个指南

添加评论

浏览统计数据:

过去的24小时: 1

过去的7天: 3

过去的30天: 13

总计 99