在此拆机指南中的精选工具

简介

Take Apart a Samsung DVD-P231 DVD Player Progressive Scan Digital Video.

这个拆解是不是维修指南。 要维修你的的Samsung DVD-P231 DVD Player Progressive Scan Digital Video,请使用我们的服务手册

  1. First make sure that the DVD player can actually turn on, this is a deconstruct but we want to make sure there are no major issues
    • First make sure that the DVD player can actually turn on, this is a deconstruct but we want to make sure there are no major issues

    • ENSURE YOUR SAFETY BY UNPLUGGING THE DEVICE BEFORE BEGINNING

    添加评论

  2. Remove the screws on the outside edge of the top covering with the bottom of the DVD Player down
    • Remove the screws on the outside edge of the top covering with the bottom of the DVD Player down

    • There will be 3 Screws, two on either side and 1 in the center top of the back side of the DVD Player

    添加评论

    • Gently cleave open the top case from the bottom case using your hands

    • The inside should appear as the second photo

    添加评论

    • Remove the 3 screws, the two upper screws swill require a smaller screwdriver

    • The second images two screws will require the larger screwdriver, make sure to not strip these

    添加评论

    • Remove all ribbons with great care gently wiggling side to side while applying force perpendicular to the circuit board

    添加评论

    • Remove the clips around the edge of the front face, there may very well be more than I show in these pictures, but make sure to do this before you proceed

    • There are two on the bottom that you press together to unclip the DVD reader

    添加评论

    • Gently tug Upwards using the front face of the DVD Player as a pivot, make sure that no clips are still connected

    • If you were successful you will notice the lip cover for the DVD tray has been removed and can be downward slid back on

    添加评论

    • Gently tilt up the board making sure to check the ribbon connections twice

    添加评论

    • Remove the screws on the back plate(side with all the ports)

    • Press in the very small and fragile tabs(image 2) with a flathead, nail, or other small tipped objects

    • turn the knob as seen in the third picture to align the hole in the case with the knob wings

    添加评论

    • Unplug the power cable from the circuit board, pay attention to the tab on the side, press it down and pull

    • Pull back the two tabs on either side of the back case and pull away

    添加评论

    • Gently slide off the copper slip around the ports if there is evidence of corrosion

    • Place in vinegar(preferably apple cider) for 30 minutes to an hour to remove the corrosion from the copper slip

    添加评论

    • Check to make sure that you have everything if you plan to reassemble this project

    • Wash you hands before any activity after this project

    添加评论

Owen Preece

于2018年04月10日注册

643 信誉积分

创作了3篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 14

总计 234