在此拆机指南中的精选工具

简介

Going to take apart my Power Mac 8600/250!

Tools:

#1 Phillips screwdriver

Spudger/Flathead screwdriver

Your hands!

这个拆解是不是维修指南。 要维修你的的Power Macintosh 8600(250),请使用我们的服务手册

There she is! i'm missing the bezel around the floppy drive :(
  • There she is! i'm missing the bezel around the floppy drive :(

添加评论

Start by pressing the big green button. And pulling the door away and up from the computer.
  • Start by pressing the big green button. And pulling the door away and up from the computer.

  • And on the Back of the door is the fan.

添加评论

  • Now it's best to lay the computer flat.

  • And to flip up the tabs, grab the handle and open.

添加评论

  • The innards, motherboard, daughter board, RAM and so fourth.

添加评论

  • Now the speaker

  • Remove the speaker wires

  • And the fan wires from the motherboard

  • Push in the two plastic tabs on either side and lift the speaker up and out.

添加评论

  • The PRAM battery!

  • Remove the housing by pulling it out and then take the battery out.

添加评论

  • The processor, firmly grasp and pull out.

  • Remove the 4 #1 Phillips screws

  • And push the 4 tabs off of the board

High failure rate - these bassas’

Mal - 回复

  • Any video card or usb card, mine happens to be an ethernet 10/100 card.

  • Unfortunately there are 6 spaces but only 3 slots on the motherboard :(

  • Remove the #1 Phillips screw and pull the card out.

添加评论

  • RAM and VRAM slots!

添加评论

  • Moving on to the CD, ZIP, and Floppy drives (best to close computer now)

  • Remove the bezels and if I had the top one remove that too.

  • Remove the 6 phillips screws and pull the metal frames out.

添加评论

  • Remove the data and power cables

  • Pay special attention to this one, it has a clip on it, it helps to use a flathead or a spudger.

  • Pull the drives out of the bay.

添加评论

  • Now the hard drive.

  • Remove the two phillips screws

  • And the data and power cables (might help to remove them as you pull the drive out)

添加评论

  • The power source

  • Remove the two connectors

  • There is a clip holding the wires in place. Separate and remove the wires. (both sets)

添加评论

  • Now remove the 4 phillips screws (it's best to start with the bottom two)

  • And pull it out while de-threading the wires.

添加评论

Plague

于2010年06月14日注册

171 信誉积分

撰写一个指南

Nice. I got a beige G3 300 Mhz, the case is similar. Maybe I could also make a teardown.

Nicolas Zbinden - 回复

添加评论

浏览统计数据:

过去的24小时: 2

过去的7天: 4

过去的30天: 41

总计 13,345