简介

If you've ever been curious about the particulars of a simple incandescent flashlight, this is the guide for you.

这个拆解是不是维修指南。 要维修你的的Panasonic Super Lite Flashlight,请使用我们的维修手册

  1. Twist the top assembly of the flashlight off by turning it counterclockwise above the rubber gasket.
    • Twist the top assembly of the flashlight off by turning it counterclockwise above the rubber gasket.

  2. Orient the top assembly with the lens downward to avoid dropping the bulb during this step.
    • Orient the top assembly with the lens downward to avoid dropping the bulb during this step.

    • Unscrew the bulb base by twisting counter-clockwise, taking care not to drop the bulb. Remove the bulb.

  3. Remove the rubber gasket from the top assembly.
    • Remove the rubber gasket from the top assembly.

  4. 所有超过US$100.00或包含 Pro Tech工具包的订单免费送货!

    浏览我们的商店
  5. Remove the reflector by applying pressure to one of the two protruding plastic tabs using a small flathead screwdriver while pulling on the reflector. The reflector should pop out; pull gently but firmly to avoid scattering the pieces. Remove the lens. The reflector should pop out; pull gently but firmly to avoid scattering the pieces. Remove the lens.
    • Remove the reflector by applying pressure to one of the two protruding plastic tabs using a small flathead screwdriver while pulling on the reflector.

    • The reflector should pop out; pull gently but firmly to avoid scattering the pieces. Remove the lens.

  6. Remove the batteries from the flashlight body.
    • Remove the batteries from the flashlight body.

  7. Insert the metal screwdriver as pictured: oriented vertically, underneath the yellow plastic piece in the switch assembly, between the metal contact of the switch and the gray plastic slider flange.
    • Insert the metal screwdriver as pictured: oriented vertically, underneath the yellow plastic piece in the switch assembly, between the metal contact of the switch and the gray plastic slider flange.

    • Pry upward to remove the yellow plastic piece; the metal contact piece may pop out with the plastic piece.

    • Once the metal and plastic are unseated from one side, pull out the metal contact and yellow plastic piece with pliers or fingers. Remove these pieces.

  8. Use pliers to pinch the gray flanges of the switch slider and apply pressure to push the switch out of the flashlight body.
    • Use pliers to pinch the gray flanges of the switch slider and apply pressure to push the switch out of the flashlight body.

Colin Mitchell

于2011年04月11日注册

222 信誉积分

撰写一个指南

团队

Cal Poly, Team 25-26, Garner Spring 2011 Cal Poly, Team 25-26, Garner Spring 2011 的会员

CPSU-GARNER-S11S25G26

3 名成员

创作了7篇指南

浏览统计数据:

过去的24小时: 0

过去的7天: 1

过去的30天: 11

总计 2,028