声誉积分: 52
7
3
1
I replaced the display assembly this weekend, but when I was attempting to reinstall the logic board (step 21 of the guide, in reverse), a small rubber bumper came loose from 'somewhere' on the board (I think).
Here's a picture of the bumper (with the broken screen as a backdrop to give you a sense of proportion). Can somebody identify where it belongs? It's seldom good when you've got parts left over!
声誉积分: 24.4千
35
16
30
It goes on top of the Logic Board, under the two Front Screen Flex Cables. I have seen a couple of iPhone 4 without this installed or just missing and they functioned perfectly.
这个答案有帮助吗？
That did it!
That was a huge help. Thanks!
声誉积分: 49
3
Also, notice there is a thick and thin side to the bumper, and the thin side should be on top, or toward the back panel.
这个答案有帮助吗？
声誉积分: 25
1
That little plastic bumper folds over the top of the logic board assembly where the Digitizer ( Front Panel) cables come up and over. If you look close at the bumper there is a small grove that is the same size as the boards thickness. Its just there to protect the Digitizer's cables from the rough surface of the logic board.
这个答案有帮助吗？
Thanks for that info... Super helpful
过去 24 小时： 1
过去 7 天： 1
过去 30 天： 3
总计 7,381
