跳转到主内容
英语
中文

正翻译步骤 9

步骤 9
Move the piece of tape so that it no longer covers the remaining two leads. If you are satisfied with the position of the cable relative to the pads on the board, proceed. If not, de-solder the first connection and try again.
  • Move the piece of tape so that it no longer covers the remaining two leads. If you are satisfied with the position of the cable relative to the pads on the board, proceed. If not, de-solder the first connection and try again.

  • Solder the two remaining pads to the logic board, being mindful of overheating the cable or board.

移动胶带,使其不再覆盖剩余的两根导线。 如果您对电缆相对于电路板上电极的位置感到满意,请继续。 如果没有,请先拆下第一个连接,然后重试。

将剩下的两个焊盘焊接到电路板上,注意电缆或电路板过热。

在开源创作共享许可协议下,你的投稿已被许可