跳转到主内容
英语
中文

正翻译步骤 8

步骤 8
Place the new battery in place and align the far contact with the outer solder pad. Use a small strip of electrical tape to hold the cable against the solder pads. Installing the battery upside down (with the cable facing up) will destroy the logic board. Place the strip of tape over the end of the battery ribbon cable to cover two of the solder pads and hold the contacts down against the logic board.
  • Place the new battery in place and align the far contact with the outer solder pad. Use a small strip of electrical tape to hold the cable against the solder pads.

  • Installing the battery upside down (with the cable facing up) will destroy the logic board.

  • Place the strip of tape over the end of the battery ribbon cable to cover two of the solder pads and hold the contacts down against the logic board.

  • Heat the rightmost contact until the solder below melts, then apply a small amount of solder to the contact, allowing it to flow through the two holes in the cable and down to the logic board.

  • Do not apply too much solder. The amount required for a proper bond is miniscule.

  • As soon as the solder has flowed into the joint, remove both the solder and the iron.

将新电池放置到位,并将远触点与外部焊盘对齐。 使用一小块电工胶带将电缆固定在焊盘上。

颠倒安装电池(电缆朝上)会损坏电路板。

将胶带条放在电池带电缆的末端以覆盖两个焊盘,并将触点向下压在电路板上。

加热最右边的触点,直到下面的焊料熔化,然后在触点上涂上少量的焊料,让它流过电缆上的两个孔,然后流到电路板。

不要使用太多的焊料。所需的合适的数量只是微乎其微的。

一旦钎料流入接头,要同时去除焊料和铁。

在开源创作共享许可协议下,你的投稿已被许可