跳转到主内容

注:你正在为你刚才查阅的指南编辑前提条件。你所做的任何更改将影响包括此步骤的8本指南

英语
中文

正翻译步骤 7

步骤 7
Insert the edge of an iPod opening tool under the steel mid plate near the bottom left corner of the Touch. Pry upward to separate the plate from the adhesive securing it to the plastic inner case.
  • Insert the edge of an iPod opening tool under the steel mid plate near the bottom left corner of the Touch.

  • Pry upward to separate the plate from the adhesive securing it to the plastic inner case.

  • If the plate is still attached to the logic board re-warm the area to loosen the adhesive, then separate the plate from the logic board using the opening tool

  • Use extreme care, the speaker is under the area shown in photo. It is connected with very thin and short wires.

  • There is a very thin ribbon cable here that connects the volume and power buttons to the logic board. Try to work around this area like shown so not to rip the cable. Be sure to hold down this cable when lifting the plate. It could stick to the plate due to residual glue. It is extremely fragile.

  • This cable will tear very easily if you are not careful.

  • There is also adhesive under the area shown in red.

将iPod开口工具的边缘插入触摸屏左下角附近的钢板下。

将用粘合剂板固定在塑料内壳上向赏撬动。

如果钢板仍连接在主板上,请重新加热该区域以松开粘合剂,然后使用打开工具将它从主板上分离。

使用时要非常小心,扬声器在照片中标注的区域之下。 它与非常细和短的电线连接。

这里有一条非常细的带状电缆,将音量和电源按钮连接到逻辑板。 尝试像这样在这个区域操作,以免破坏电缆。 抬起平板时一定要抓住这根电缆。 由于有胶水残留,可能会粘在盘子上。 这是非常脆弱的。

如果不小心的话这根线就很容易断裂。

红色标注区域下面也有粘合剂。

在开源创作共享许可协议下,你的投稿已被许可