跳转到主内容

注:你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的3指南

英语
中文

正翻译步骤 1

步骤 1
Remove the two 3.3 mm T5 Torx screws securing the display cable assembly. Take care not to lose the small retaining bracket located under the right screw. If it comes loose, note the orientation shown here for reassembly. The small tab on the outer left edge should be hooked under the perforated metal shield. Take care not to lose the small retaining bracket located under the right screw. If it comes loose, note the orientation shown here for reassembly. The small tab on the outer left edge should be hooked under the perforated metal shield.
  • Remove the two 3.3 mm T5 Torx screws securing the display cable assembly.

  • Take care not to lose the small retaining bracket located under the right screw. If it comes loose, note the orientation shown here for reassembly. The small tab on the outer left edge should be hooked under the perforated metal shield.

在此插入翻译

在此插入翻译

在开源创作共享许可协议下,你的投稿已被许可