跳转到主内容
英语
中文

正翻译步骤 7

步骤 7
The only thing holding the camera to the board at this point is another flexible printed circuit cable with some adhesive on the connector and hold down. This time I started from the connector end and carefully but with pressure used my 1.0 flathead bit to cleanly scrape off the goo. Flip up the connector hold down "latch" with a spudger or the flathead bit and remove the flex cable and pull the camera module out.
PCB and Camera Module
  • The only thing holding the camera to the board at this point is another flexible printed circuit cable with some adhesive on the connector and hold down.

  • This time I started from the connector end and carefully but with pressure used my 1.0 flathead bit to cleanly scrape off the goo.

  • Flip up the connector hold down "latch" with a spudger or the flathead bit and remove the flex cable and pull the camera module out.

在此插入翻译

在此插入翻译

在此插入翻译

在开源创作共享许可协议下,你的投稿已被许可