跳转到主内容
英语
中文

正翻译步骤 6

步骤 6
After the PCB board is taken loose from the housing, we see that we have two wires attaching a small speaker to the housing, The speaker is easily removed with a thin pry tool slipped into the speaker cavity or, a lesser preferred method that I used, grab the two wires close to the speaker and carefully but firmly lift the front edge of the speaker upwards to get the initial adhesive to release.  At that point you can grab the speaker and pull it out from the cavity.
Remove speaker from housing
  • After the PCB board is taken loose from the housing, we see that we have two wires attaching a small speaker to the housing,

  • The speaker is easily removed with a thin pry tool slipped into the speaker cavity or, a lesser preferred method that I used, grab the two wires close to the speaker and carefully but firmly lift the front edge of the speaker upwards to get the initial adhesive to release. At that point you can grab the speaker and pull it out from the cavity.

在此插入翻译

在此插入翻译

在开源创作共享许可协议下,你的投稿已被许可