跳转到主内容

注:你正在为你查阅的指南编辑前提条件。你所做的任何更改将影响包括此步骤的本指南

英语
中文

正翻译步骤 1

Step 1
Peel off the four black tamper-evident stickers covering the heat sink mounting screws. Remove the four T10 screws that secure the heat sink from the backside of the logic board.
  • Peel off the four black tamper-evident stickers covering the heat sink mounting screws.

  • Remove the four T10 screws that secure the heat sink from the backside of the logic board.

  • During reassembly, tighten these screws one full turn at a time, alternating in a cross pattern. This will gradually increase the clamping pressure evenly across the surface of the CPU. Continue gradually tightening the screws until they're snug and the entire spring plate lays flat against the logic board.

在此插入翻译

在此插入翻译

在此插入翻译

在开源创作共享许可协议下,你的投稿已被许可