菜单

你的设置

我的工作台

快速访问设备的指南，配件和论坛
我的购物车

购物车是空的

浏览我们的商店

注：你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的21指南。

返回指南
英语
中文
下一步

正翻译步骤 1

步骤 1
Make sure the battery is disconnected before you disconnect or reconnect the cables in this step. Use a spudger or a fingernail to disconnect the two lower display connectors by prying them straight up from their sockets on the logic board. To reconnect these cables, press down on one end until it clicks into place, then repeat on the opposite end. Do not press down on the middle. If the connector is even slightly misaligned, the connector can bend, causing permanent damage.

  • Make sure the battery is disconnected before you disconnect or reconnect the cables in this step.

  • Use a spudger or a fingernail to disconnect the two lower display connectors by prying them straight up from their sockets on the logic board.

  • To reconnect these cables, press down on one end until it clicks into place, then repeat on the opposite end. Do not press down on the middle. If the connector is even slightly misaligned, the connector can bend, causing permanent damage.

  • If you have a blank screen, white lines on the display, or partial or complete lack of touch response after reassembling your phone, try disconnecting and carefully reconnecting both of these cables and make sure they are fully seated.

在该步骤中，断开或重新连接排线之前，请确保电池已经断开连接。

使用撬棒或者指甲来将两条显示排线从逻辑板上的插座中撬出。

来连接这些排线插头的时候，先按压插头的一侧来确保其已经安装到位，然后再按压另一端。 切勿在中部按压。 如果插头稍微不对准，插头可能会弯曲，造成永久性损坏。

如果在重新安装显示屏后，发生显示屏无法显示内容、显示白线、部分或全部触摸失灵等情况，请重新连接排线插头，确保安装到位。

在开源创作共享许可协议下，你的投稿已被许可。