跳转到主内容

修复你的物品

维修的权力

商店

英语
中文

正翻译步骤 11

步骤 11
If you were unable to remove all the EMI shields, use compressed air or a blow-dryer on its cold setting to blow underneath the shields and dry out any trapped alcohol. When all components look clean and dry, reapply any EMI shields that you removed and begin to reassemble the phone with a new battery, and a new display if necessary.
  • If you were unable to remove all the EMI shields, use compressed air or a blow-dryer on its cold setting to blow underneath the shields and dry out any trapped alcohol.

  • When all components look clean and dry, reapply any EMI shields that you removed and begin to reassemble the phone with a new battery, and a new display if necessary.

  • Do not completely assemble the phone yet. Make sure internal components are screwed down and everything is plugged in, including the battery and display cables, but do not apply adhesive, screw down cover plates, replace external screws, or seat the display.

  • It is safe to start the phone like this, but turn the phone off before you start working inside it again. You just want to test the phone while keeping the internals accessible in case there are any problems.

如果您不能移除所有的电磁保护罩,使用压缩空气或有凉风模式的吹风机来将保护罩下残留的异丙醇吹干。

所有元件看起来干净、干燥后,将您之前卸下的保护罩重新安装好,然后使用一块新电池和一块新屏幕(有必要的话)来重新组装您的手机。

先不要完全组装好手机。确保所有的内部元件固定好,所有排线插头插好(包括电池和屏幕排线),但先不要贴电池胶、安装排线上的保护罩、安装外部的螺丝和扣上屏幕。

现在手机应该可以安全开机,但是进行组装之前请将手机关闭。现在仅仅是为了测试手机功能是否正常。

在开源创作共享许可协议下,你的投稿已被许可