Use the opening picks to slice through any remaining adhesive and open the phone slightly.
Remove the glass from the phone.
|[* icon_note] The fingerprint sensor cable connects the phone to the rear glass near the main camera. The cable is very short and should disconnect as the rear glass is removed.|
|[* icon_caution] As you lift the glass, peek in to be sure the orange cable with a blue connector has disconnected.|
|[* black] Use the opening picks to slice through any remaining adhesive and open the phone slightly.|
|[* icon_caution] If the fingerprint sensor cable seems snagged or stays taut do not open the phone any further. Disconnect the connector with the point of a spudger before proceeding.|
|[* icon_reminder] During reassembly, in order to reconnect the fingerprint sensor cable, first angle the back cover into position until the cable connector lines up perfectly over its socket. Then, use the flat end of your spudger to gently snap the connector into place by pressing it straight down.|
|[* black] Remove the glass from the phone.|