修复你的物品

维修的权力

商店

注：你正在为你刚才查阅的指南编辑前提条件。你所做的任何更改将影响包括此步骤的14本指南。

返回指南
英语
中文
上一步 下一步

正翻译步骤 7

步骤 7
The fingerprint sensor cable connects the phone to the rear glass near the main camera. The cable is very short and should disconnect as the rear glass is removed. As you lift the glass, peek in to be sure the orange cable with a blue connector has disconnected.

  • The fingerprint sensor cable connects the phone to the rear glass near the main camera. The cable is very short and should disconnect as the rear glass is removed.

  • As you lift the glass, peek in to be sure the orange cable with a blue connector has disconnected.

  • Use the opening picks to slice through any remaining adhesive and open the phone slightly.

  • If the fingerprint sensor cable seems snagged or stays taut do not open the phone any further. Disconnect the connector with the point of a spudger before proceeding.

  • During reassembly, in order to reconnect the fingerprint sensor cable, first angle the back cover into position until the cable connector lines up perfectly over its socket. Then, use the flat end of your spudger to gently snap the connector into place by pressing it straight down.

  • Remove the glass from the phone.

指纹传感器线缆与手机在后玻璃面板靠近主摄像头的位置连接。 这个线缆十分的短，在移除玻璃面板的时候也要断开。

抬起玻璃杯时，请仔查看以确保带有蓝色连接器的橙色电缆已断开连接。

使用打开工具将残留粘合剂分离，小心地打开手机。

如果指纹传感器电缆看起仍处于连接，请勿继续抬起面板，在继续之前请用撬棒来断开连接。

移除玻璃后面板。

[* icon_note] The fingerprint sensor cable connects the phone to the rear glass near the main camera. The cable is very short and should disconnect as the rear glass is removed.
[* icon_caution] As you lift the glass, peek in to be sure the orange cable with a blue connector has disconnected.
[* black] Use the opening picks to slice through any remaining adhesive and open the phone slightly.
[* icon_caution] If the fingerprint sensor cable seems snagged or stays taut do not open the phone any further. Disconnect the connector with the point of a spudger before proceeding.
[* icon_reminder] During reassembly, in order to reconnect the fingerprint sensor cable, first angle the back cover into position until the cable connector lines up perfectly over its socket. Then, use the flat end of your spudger to gently snap the connector into place by pressing it straight down.
[* black] Remove the glass from the phone.

在开源创作共享许可协议下，你的投稿已被许可。