Skip to main content
英语
中文

正翻译步骤 29

Step 29
Lift and remove the battery. Before installing your new battery, remove all the old adhesive from the MacBook Pro's case.
  • Lift and remove the battery.

  • Before installing your new battery, remove all the old adhesive from the MacBook Pro's case.

  • With a little luck, you can slowly pull out each strip of adhesive with your fingers.

  • Otherwise, soak each strip of adhesive with a bit of adhesive remover for 2-3 minutes, and then scrape it out with a plastic tool. This can take quite a bit of work, so be patient.

  • Mop up any remaining adhesive remover and give your MacBook Pro a few minutes to air dry.

  • The replacement battery included in your iFixit kit comes with adhesive pre-installed. Test the battery's fit and alignment carefully before peeling off the film covering the adhesive, and then press each cell firmly into place. If any additional films/liners are present that weren't on your original battery, remove them now.

  • Calibrate your newly installed battery: charge it to 100%, and keep charging it for at least 2 more hours. Unplug and use it normally to drain the battery. When you see the low battery warning, save your work, and keep your laptop on until it goes to sleep due to low battery. Wait at least 5 hours, then charge your laptop uninterrupted to 100%.

  • If you notice any unusual behavior or problems after installing your new battery, you may need to reset your MacBook Pro's SMC.

提起并取出电池。

在重新安装你的新电池之前,从MacBook Pro的机身上除去剩余的胶。

幸运的话,你可以用手指慢慢地将每条胶条撕开

否则,你就得用除胶剂浸泡没条胶2-3分钟,然后用塑料工具刮掉它们。这颇具工作量,请耐心点。

除去任何残留的除胶剂,并给你的MacBook Pro几分钟晾干。

你的iFixit工具包里的新电池上已经粘好了胶。在你揭掉胶上的膜之前先矫正好电池的位置,然后再把每个电池组件严丝合缝地放到位置上。如果你的新电池上有一些在原来的电池的相同位置没有出现的胶,马上把它们移除。

校准 你新安装的电池: 将电池充电至100%并继续充电至少两小时,然后拔掉电源正常使用你的电脑。当出现低电量警告时,保存你的工作并继续使用电脑直至电量低自动休眠。静置至少5小时后一次性充电至100%。

如果你在安装新电池以后注意到任何异常举动或者问题,也许你需要重置你 MacBook Pro 的 SMC。

在开源创作共享许可协议下,你的投稿已被许可