翻译步骤＃11 - iRobot Roomba 880 Bumper Sensors Replacement - iFixit

修复你的物品

维修的权力

商店

英语

中文

上一步下一步

正翻译步骤 11

步骤 11

Remove the 6 bumper sensors from the side of your device.

This will require some tugging as the sensors are securely situated in the device currently. We recommend using a spudger if they are particularly difficult.

You might need to cut the tape that is currently holding several sets of bumper sensor wires together. It might be helpful to tape the new sensor wires back together when putting your device back together.

Remove the 6 bumper sensors from the side of your device.
This will require some tugging as the sensors are securely situated in the device currently. We recommend using a spudger if they are particularly difficult.
You might need to cut the tape that is currently holding several sets of bumper sensor wires together. It might be helpful to tape the new sensor wires back together when putting your device back together.
As you can see in the third photo the cable from the bumper sensor was originally connected to the motherboard.

在开源创作共享许可协议下，你的投稿已被许可。