跳转到主内容

注:你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的4指南

英语
法语

正翻译步骤 3

步骤 3
Flip the console over so the bottom is facing up. Use a T8 Torx Security  screwdriver to remove the three black 7mm screws in the back panel. (7000-series models only); or one 7mm screw (the middle one) with 7100-series models and the warranty sticker to the left. Remove the bottom cover in the same way as the top cover. Grip the cover on both sides and pull up until it clicks. Then slide the cover off; With 7100-series models, pay attention to the two clips that replace the corresponding screws.
  • Flip the console over so the bottom is facing up.

  • Use a T8 Torx Security screwdriver to remove the three black 7mm screws in the back panel. (7000-series models only); or one 7mm screw (the middle one) with 7100-series models and the warranty sticker to the left.

  • Remove the bottom cover in the same way as the top cover. Grip the cover on both sides and pull up until it clicks. Then slide the cover off; With 7100-series models, pay attention to the two clips that replace the corresponding screws.

Retournez la console de sorte que le bas soit orienté vers le haut.

Utilisez un tournevis de sécurité Torx T8 pour retirer les trois vis noires de 7 mm du panneau arrière.

Retirez le capot inférieur de la même manière que le capot supérieur. Saisissez le couvercle des deux côtés et tirez vers le haut jusqu'à ce qu'il s'enclenche. Faites ensuite glisser le couvercle.

[* black] Flip the console over so the bottom is facing up.
-[* red] Use a T8 Torx Security screwdriver to remove the three black 7mm screws in the back panel.
-[* black] Remove the bottom cover in the same way as the top cover. Grip the cover on both sides and pull up until it clicks. Then slide the cover off.
+[* red] Use a T8 Torx Security screwdriver to remove the three black 7mm screws in the back panel. (7000-series models only); or ***one*** 7mm screw (the middle one) with ''7100-series'' models ***and*** the warranty sticker to the left.
+[* black] Remove the bottom cover in the same way as the top cover. Grip the cover on both sides and pull up until it clicks. Then slide the cover off; ***''With 7100-series models,''*** pay attention to the two clips that replace the corresponding screws.

在开源创作共享许可协议下,你的投稿已被许可