跳转到主内容

注:你正在为你刚才查阅的指南编辑前提条件。你所做的任何更改将影响包括此步骤的2本指南

英语
中文

正翻译步骤 5

步骤 5
If you successfully removed both adhesive strips, move on to the next step. Otherwise, you will need to pry the battery from the rear case. Prepare an iOpener and apply it to the back of the rear case, directly over the battery. Alternatively, you can apply heat using a heat gun or  hair dryer.
  • If you successfully removed both adhesive strips, move on to the next step. Otherwise, you will need to pry the battery from the rear case.

  • Prepare an iOpener and apply it to the back of the rear case, directly over the battery. Alternatively, you can apply heat using a heat gun or hair dryer.

  • After about a minute, remove the iOpener, flip the phone over and use a plastic card to break up any remaining adhesive behind the battery.

  • Avoid bending the battery. Damage to the battery may release dangerous chemicals, and could start a fire.

  • Do not pry under the top third of the battery, you may damage the volume button ribbon cable.

如果你成功取出胶条,就开始下一步。否则,你需要把电池从后壳上撬下来。

准备iOpener并且把它放在后壳上加热电池。还有别的方法,比如用热风枪或者吹风机。

用iOpener加热大概1分钟,翻转机身然后用塑料卡片分离电池上的胶条。

要避免使电池变形。损坏电池的话可能释放出有毒的化学物质并且起火。

不要翘到电池顶部三分之一处,否则会损坏音量键排线。

在开源创作共享许可协议下,你的投稿已被许可