跳转到主内容

注:你正在为你查阅的指南编辑前提条件。你所做的任何更改将影响包括此步骤的本指南

英语
中文

正翻译步骤 8

步骤 8
If you successfully removed both adhesive strips, move on to the next step. Otherwise, you will need to pry the battery from the rear case. Prepare an iOpener and apply it to the back of the rear case, directly over the battery. Alternatively, you can apply heat using a heat gun or  hair dryer.
  • If you successfully removed both adhesive strips, move on to the next step. Otherwise, you will need to pry the battery from the rear case.

  • Prepare an iOpener and apply it to the back of the rear case, directly over the battery. Alternatively, you can apply heat using a heat gun or hair dryer.

  • After about a minute, remove the iOpener, flip the phone over and use a plastic card to break up any remaining adhesive behind the battery.

  • Avoid bending the battery. Damage to the battery may release dangerous chemicals, and could start a fire.

  • Do not pry under the top third of the battery, you may damage the volume button ribbon cable.

如果你成功地移除胶带,继续下一步。否则,你将需要从后盖撬开电池。

准备一个适用于iOpener的后盖后,电池直接在。或者,你可以加热用热风枪或电吹风。

大约一分钟后,取出iOpener,翻转手机和使用塑料卡打破任何剩余的粘合剂落后电池。

避免弯曲电池。对电池的损伤可释放有害的化学物质,并能引起火灾。

不要把电池的前第三下,你可能会损坏音量键排线。

在开源创作共享许可协议下,你的投稿已被许可