翻译步骤＃1 - iPod Nano 1st Generation Battery & Logic Board Replacement - iFixit

修复你的物品

维修的权力

商店

注：你正在为你刚才查阅的指南编辑前提条件。你所做的任何更改将影响包括此步骤的6本指南。

英语

中文

下一步

正翻译步骤 1

步骤 1

Remove any kapton tape over the screws, if necessary.

Remove any kapton tape over the screws, if necessary.
Remove the following 3 screws:
Two 3 mm Phillips screws near the dock connector.
One 4 mm Phillips screw along the edge of the logic board.
During reassembly, make sure to put back any tape or plastic you remove. This will prevent any shorts between the logic board and the rear panel. If your tape is unusable, kapton tape can be purchased online.

在开源创作共享许可协议下，你的投稿已被许可。