跳转到主内容

修复你的物品

维修的权力

配件 & 工具

英语
中文

LG G3 屏幕闪烁并老化

指南信息

= 完成 = 未完成
    the battary out. battery out. [ ] 2*Unscrew the whole back. 3*You[ ] 3*You will se see a connector down at the charger port take them off and you can blow some air to take the dirt off. off. [ ] 4* Take some paper and fold it 4 to 6 times(small one) [ … ] 5* After folding it make sure it is the size of the connector that is next to the Camera. [ … ] 6*Place the folden paper on top of the connector. [ … ] 7*Slowly get back all the plastic covers. [ … ] 8*Screw in all the screws. 9*Place[ ] 9*Place the battary,SD battery, SD Card and the Sim back back [ ] 10*Power on the Phone. [ … ] 99.9% It will work. [ … ] UPDATE: If [ ] If you want to take it a step further , further, [ ] get some thermal paste and[ ] and remove the whole circuit board and but put some on the spot (as shown on in the picture) do NOT put too much a dot will be enough... [ ] after that that, you can go ahead an and place the circuit board back in place, then place the paper on the connector(follow the steps 6-10) [ … ] *Even thermal pad might do the job. [ … ] Thanks, I[ ] I hope this will fix the problem !
    the battary out. battery out. [ ] 2*Unscrew the whole back. 3*You[ ] 3*You will se see a connector down at the charger port take them off and you can blow some air to take the dirt off. off. [ ] 4* Take some paper and fold it 4 to 6 times(small one) [ … ] 5* After folding it make sure it is the size of the connector that is next to the Camera. [ … ] 6*Place the folden paper on top of the connector. [ … ] 7*Slowly get back all the plastic covers. [ … ] 8*Screw in all the screws. 9*Place[ ] 9*Place the battary,SD battery, SD Card and the Sim back back [ ] 10*Power on the Phone. [ … ] 99.9% It will work. [ … ] UPDATE: If [ ] If you want to take it a step further , further, [ ] get some thermal paste and[ ] and remove the whole circuit board and but put some on the spot (as shown on in the picture) do NOT put too much a dot will be enough... [ ] after that that, you can go ahead an and place the circuit board back in place, then place the paper on the connector(follow the steps 6-10) [ … ] *Even thermal pad might do the job. [ … ] Thanks, I[ ] I hope this will fix the problem !

      描述一下你正在修理的device的特别配件或组件。例如:电池

      创建一个标题。

      这个简短的一两句总结将会出现在搜索结果中。

      在读者深入阅读这份指南之前做好背景信息交流。

      说明(指南)步骤

      第 1 步 — 把折叠纸放在这里!

      把纸放在这个连接器上!

      第 2 步 — 硅脂

      一个小的点会比填满更多的东西做得更好!

      在开源创作共享许可协议下,你的投稿已被许可