跳转到主内容

注:你正在为你查阅的指南编辑前提条件。你所做的任何更改将影响包括此步骤的本指南

英语
中文

正翻译步骤 6

步骤 6
The ball joint is held to the control arm by three 18 mm bolts. Remove the bottom two nuts with a breaker bar or long wrench. Place a breaker bar over the gold nut on the bottom of the control arm.
  • The ball joint is held to the control arm by three 18 mm bolts.

  • Remove the bottom two nuts with a breaker bar or long wrench.

  • Place a breaker bar over the gold nut on the bottom of the control arm.

  • The breaker bar alone will not be able to loosen the nut, since the bolt is free to rotate.

  • Place an 18 mm box end wrench over the bolt on top of the control arm.

  • Turn the breaker bar and the wrench in their respective counterclockwise directions to loosen and remove the third ball joint-to-control arm bolt.

在此插入翻译

在此插入翻译

在此插入翻译

在此插入翻译

在此插入翻译

在此插入翻译

在开源创作共享许可协议下,你的投稿已被许可