注：你正在为你刚才查阅的指南编辑前提条件。你所做的任何更改将影响包括此步骤的21本指南。
Make sure the battery is disconnected before you disconnect or reconnect the cables in this step.
Use a spudger or a fingernail to disconnect the two lower display connectors by prying them straight up from their sockets on the logic board.
To reconnect these cables, press down on one end until it clicks into place, then repeat on the opposite end. Do not press down on the middle. If the connector is even slightly misaligned, the connector can bend, causing permanent damage.
If you have a blank screen, white lines on the display, or partial or complete lack of touch response after reassembling your phone, try disconnecting and carefully reconnecting both of these cables and make sure they are fully seated.
您的所有投稿皆享有基于开源创作共享许可协议（CC BY-NC-SA）的著作权利。
下一行
上一行
在下面插入新的一行
在上面插入新的一行
缩进当前行
取消缩进当前行
删除当前行
导航到下一步。
导航到上一步。
打开帮助
