跳转到主内容

注:你正在为你查阅的指南编辑前提条件。你所做的任何更改将影响包括此步骤的本指南

英语
中文

正翻译步骤 5

步骤 5
The next few steps require a soldering iron.
  • The next few steps require a soldering iron.

  • The ends of the battery leads are fed through small holes in the logic board and held in place by a small amount of solder.

  • Begin by heating the exposed end of the white battery lead with the tip of a soldering iron while simultaneously pulling the lead away from the connection, using tweezers to grasp the lead by the insulation.

  • Due to the delicate nature of electronic components, it is imperative to limit the amount of heat transferred from the soldering iron to the logic board. An easy way to accomplish this is to pull on the battery lead with light continuous tension while the soldering iron heats up the connection. As soon as the solder melts and the lead slides out, immediately lift the solder tip off the connection to avoid damage.

在此插入翻译

在此插入翻译

在此插入翻译

在此插入翻译

在开源创作共享许可协议下,你的投稿已被许可