跳转到主内容

注:你正在为你刚才查阅的指南编辑前提条件。你所做的任何更改将影响包括此步骤的14本指南

英语
中文

正翻译步骤 7

步骤 7
Remove the following screws securing the logic board to the case:
  • Remove the following screws securing the logic board to the case:

  • One 2.5 mm Phillips screw near the vibrator motor

  • One 2.4 mm Phillips screw

  • One 3.6 mm standoff along the side of the logic board nearest the battery opening.

  • Use a standoff driver bit and driver handle to remove the single 3.6 mm standoff screw.

  • In a pinch, a small flathead screwdriver will do the job—but use extra caution to ensure it doesn't slip and damage surrounding components.

卸下下列将逻辑板与后壳固定的螺丝。

一个位于振动模块的2.5 mm Phillips 螺丝

一个 2.4 mm Phillips螺丝

一个3.6 mm螺丝在逻辑板右侧最接近电池开口位置。

使用专用螺丝刀或者小型平头起子来卸下单个的3.6mm隔离柱。

[* black] Remove the following screws securing the logic board to the case:
[* red] One 2.5 mm Phillips screw near the vibrator motor
[* orange] One 2.4 mm Phillips screw
[* yellow] One 3.6 mm standoff along the side of the logic board nearest the battery opening.
[* icon_note] Use a [product|IF145-343|standoff driver bit|new_window=true] or a small flathead screwdriverand [product|IF145-326|driver handle|new_window=true] to remove the single 3.6 mm standoff screw.
[* icon_caution] In a pinch, a small flathead screwdriver will do the job—but use extra caution to ensure it doesn't slip and damage surrounding components.
[* icon_note] Use a [product|IF145-343|standoff driver bit|new_window=true] or a small flathead screwdriverand [product|IF145-326|driver handle|new_window=true] to remove the single 3.6 mm standoff screw.
[* icon_caution] In a pinch, a small flathead screwdriver will do the job—but use extra caution to ensure it doesn't slip and damage surrounding components.

在开源创作共享许可协议下,你的投稿已被许可