跳转到主内容

注:你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的指南

英语
中文

正翻译步骤 1

步骤 1
Use the spudger to pry up each side of the lens assembly Flat-Topped Connector at the bottom of the motherboard. Holding back the lens assembly ribbon cable, use the spudger to lift the Zero Insertion Force (ZIF)  connector tab .  Slide out the ribbon cable. Be sure you are prying up on the hinged retaining flap, not the connector itself.
  • Use the spudger to pry up each side of the lens assembly Flat-Topped Connector at the bottom of the motherboard.

  • Holding back the lens assembly ribbon cable, use the spudger to lift the Zero Insertion Force (ZIF) connector tab . Slide out the ribbon cable.

  • Be sure you are prying up on the hinged retaining flap, not the connector itself.

  • Use the spudger to lift the Zero Insertion Force (ZIF) connector tab located on the flash unit. Remove the ribbon cable.

在此插入翻译

在此插入翻译

在此插入翻译

在此插入翻译

在开源创作共享许可协议下,你的投稿已被许可