跳转到主内容

注:你正在为你查阅的指南编辑前提条件。你所做的任何更改将影响包括此步骤的本指南

英语
中文

正翻译步骤 1

步骤 1
Disconnect the orange hard drive ribbon cable from the logic board. Remove tape as necessary and use a spudger (or carefully push a credit card under the tape) to carefully loosen the adhesive securing the sleep light and IR sensor connectors to the top of the hard drive.
  • Disconnect the orange hard drive ribbon cable from the logic board.

  • Remove tape as necessary and use a spudger (or carefully push a credit card under the tape) to carefully loosen the adhesive securing the sleep light and IR sensor connectors to the top of the hard drive.

  • You may find it best to loosen the left edge, then the right edge, then the center of the tape to attack it from all points, so as to gently apply force to the smallest possible sticky surface.

在此插入翻译

在此插入翻译

在此插入翻译

在开源创作共享许可协议下,你的投稿已被许可