跳转到主内容
英语
中文

正翻译步骤 3

步骤 3
Use a Phillips head screwdriver to remove the two larger screws. The two smaller screws (orange) were a little tricky. They are screwed down very tight. I started with a #0 phillips head and slightly stripped the screw head. Not enough to destroy it. I recommend using a #1 phillips head on these. I also used a small rubber grip in order to get a better grip on my screwdriver. Made it much easier. Once screws are removed lift the plastic frame from the left side and remove it from the top of the power brick and flip it over.
Remove Screws
  • Use a Phillips head screwdriver to remove the two larger screws.

  • The two smaller screws (orange) were a little tricky. They are screwed down very tight. I started with a #0 phillips head and slightly stripped the screw head. Not enough to destroy it. I recommend using a #1 phillips head on these. I also used a small rubber grip in order to get a better grip on my screwdriver. Made it much easier.

  • Once screws are removed lift the plastic frame from the left side and remove it from the top of the power brick and flip it over.

  • Unlike the X360 power brick, the light diffuser does not need to be removed from the power supply. If you want to remove it anyway simply grab it with your fingers and lift it out.

  • When I used a can of air duster to clean the inside, the smaller metal sheet (left side) immediately blew out. If this happens don't panic. There's tape on the bottom side. Simply put it back in with a little pressure to hold it down and you're good to go.

  • These screws serve no purpose. There was nothing under there. Unless you have a different variation than mine there is no need to remove these screws.

使用Phillips头的螺丝刀来移除两颗最大的螺丝。

两颗小的螺丝(橘色),有点棘手。 他们被固定的十分紧。 我一开始用#0 phillips 螺丝刀,有点滑丝。 但不足够将螺丝刀弄坏,我推荐使用#1 phillips螺丝头来卸这些螺丝。 我也使用了橡胶小手柄来更好地抓住螺丝刀。 让整个拆卸工作更加容易。

一旦所有的螺丝移除,从左侧框架中抬起,将其从电源适配器顶部取下,并将其翻转过来。

与Xbox 360 电源适配器不同的是,光扩散板不需要从电源适配器中取出,如果您想取下它,只需要用手指将其提起卸下。

当我使用罐装空气除尘剂清洁内部时,小的金属板(左侧),被吹出来了,别担心。 它的底部有胶粘,将其放回原位稍微按压一下就好了。

这些螺丝没有任何用途,除非与我的电源适配器结构有出入,就不需要移除这些螺丝。

在开源创作共享许可协议下,你的投稿已被许可