跳转到主内容

注:你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的指南

英语
中文

正翻译步骤 2

步骤 2
In the following steps you will be cutting the adhesive under the battery, and prying it off of the rear case.
  • In the following steps you will be cutting the adhesive under the battery, and prying it off of the rear case.

  • The adhesive is laid out as shown in this image: two strips along the long edges, and two shorter strips perpendicular in the center.

  • To avoid damaging the battery, use plastic tools, heat, and patience. Do not puncture, bend, or overheat the battery.

  • Do not pry near the logic board, you could damage your iPad.

  • If you are performing this procedure on the Wi-Fi version, it is safe to insert pry tools from the upper, lower, and left edges of the battery. For the LTE version, only pry from the lower and left edges to avoid damaging other components.

在此插入翻译

在此插入翻译

在此插入翻译

在此插入翻译

在此插入翻译

在开源创作共享许可协议下,你的投稿已被许可