跳转到主内容

修复你的物品

维修的权力

配件 & 工具

英语
中文

正翻译步骤 9

步骤 9
Guide the new filter back up and around the drive shaft, being careful not to get dirt or debris on the seal of the oil filter. Place the threaded end of the oil filter onto the engine's oil filter threads and turn the filter clockwise by hand until it is snug. Tightening the filter should require a moderate amount of your strength, but not all of it. If the filter is difficult to turn at the beginning of its threads, stop! You may be cross threading the oil filter. Re-align the oil filter and try again.
  • Guide the new filter back up and around the drive shaft, being careful not to get dirt or debris on the seal of the oil filter.

  • Place the threaded end of the oil filter onto the engine's oil filter threads and turn the filter clockwise by hand until it is snug. Tightening the filter should require a moderate amount of your strength, but not all of it.

  • If the filter is difficult to turn at the beginning of its threads, stop! You may be cross threading the oil filter. Re-align the oil filter and try again.

  • Do not over-tighten your oil filter by using a wrench. Doing so may cause the oil filter seal to leak and will make removing the oil filter very difficult in the future.

  • Remove the oil drain pan from under the car.

让油滤穿过驱动轴,并注意不要让油滤密封垫圈上沾染污物或碎屑。

将滤油器的螺纹端放在发动机的油滤螺纹上,然后用手顺时针转动油滤,直至其紧贴。 拧紧油滤需要适度的力量,但并不是大力。

如果过滤器在线程开始时就很难拧动,请停止! 你可能会损坏油滤。 重新对准油滤,然后重试。

使用扳手不要过度拧紧油滤。 否则可能导致油滤密封损坏,并将来会使油滤更换工作变得非常困难。

从汽车下方取走排油盘。

在开源创作共享许可协议下,你的投稿已被许可