Skip to main content
英语
中文

正翻译步骤 13

Step 13
Grab the excess wire with your tweezers, and bending back and forth, gently snap it off. Repeat the same procedure for the other end. If you break your solder joint by twitching the leftover wire carefully back and forth, the joint was too weak to begin with. If you break your solder joint by twitching the leftover wire carefully back and forth, the joint was too weak to begin with.
Removing the excess wire
  • Grab the excess wire with your tweezers, and bending back and forth, gently snap it off. Repeat the same procedure for the other end.

  • If you break your solder joint by twitching the leftover wire carefully back and forth, the joint was too weak to begin with.

在此插入翻译

在此插入翻译

在开源创作共享许可协议下,你的投稿已被许可