跳转到主内容

注:你正在为你刚才查阅的指南编辑前提条件。你所做的任何更改将影响包括此步骤的3本指南

英语
中文

正翻译步骤 3

步骤 3
Try not to wrinkle  the strips during this procedure—they will become very difficult to deal with and will not straighten out again. Pull one of the adhesive strips straight out, towards the bottom of the iPhone. For best results, pull the strip at a 60º angle or less.
  • Try not to wrinkle the strips during this procedure—they will become very difficult to deal with and will not straighten out again.

  • Pull one of the adhesive strips straight out, towards the bottom of the iPhone.

  • For best results, pull the strip at a 60º angle or less.

  • The strip will stretch to many times its original length. Continue to pull steadily, re-grabbing the strip closer to the iPhone if necessary.

  • Continue pulling until the strip is fully removed.

  • If the battery adhesive tabs break off at any point during the removal process, use your fingers or blunt tweezers to retrieve the remaining length of adhesive, and continue pulling.

  • If one of the adhesive strips breaks under the battery during this procedure, and cannot be retrieved, remove the remaining strip, and then skip to Step 48.

在撕的过程, 记得保持胶带平整, 不要让胶带起皱。起皱后的胶带会黏在一起, 或造成在拉扯中造成断裂。

捏住胶带的边缘, 轻缓地向屏幕底部用力拉出。

若你想顺利的完成, 最佳的撕胶角度为60º 或比60º 更小皆可。

胶带在撕的过程中, 会造成胶带的长度比原先的还长好几倍, 但没关系, 就请继续撕, 必要的时候, 可从靠近电池附近的地方开始撕。

慢慢地继续拉扯胶带, 直到胶带完全撕掉。

若在撕胶带的过程中, 造成胶带断裂的话, 请使用手指或是镊子捏住剩下的胶带, 就可以继续撕掉剩余的胶带。

如果任意一条胶带断裂, 而且电池仍然无法取下, 请直接跳至执步骤48。

在开源创作共享许可协议下,你的投稿已被许可