跳转到主内容

注:你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的指南

英语
中文

正翻译步骤 1

步骤 1
Reheat the iOpener in the microwave for one minute. Remember to be careful not to overheat the iOpener during the repair procedure. Wait at least two minutes before reheating the iOpener, and never microwave it for more than one minute. Place the heated iOpener on the back of the iPad just right of center (the side opposite the rear facing camera). Let it sit there for 90 seconds to soften the battery adhesive.
  • Reheat the iOpener in the microwave for one minute.

  • Remember to be careful not to overheat the iOpener during the repair procedure. Wait at least two minutes before reheating the iOpener, and never microwave it for more than one minute.

  • Place the heated iOpener on the back of the iPad just right of center (the side opposite the rear facing camera). Let it sit there for 90 seconds to soften the battery adhesive.

  • Move the iOpener to the center of the back of the iPad and let the iOpener sit for another 90 seconds.

  • If the iOpener cools significantly between sittings, reheat it for another minute.

  • Move the iOpener to the left edge (the side with the rear facing camera) of the back of the iPad and let the iOpener sit for another 90 seconds.

把 iOpener 在微波炉里加热一分钟。

记住注意不要在修理过程中过度加热iOpener 。至少间隔两分钟后再加热iOpener ,用微波炉加热不要超过一分钟。

将 iOpener放置在iPad的背面,正好位于中心(朝摄像头的对面)。加热90秒,以软化电池胶粘剂。

把 iOpener 移到iPad背面的中心,让 iOpener 加热90秒。

如果iOpener在加热期间冷却明显,再加热一分钟。

将iOpener到iPad背面的左边(背面有摄像头的一侧),让 iOpener 加热90秒。

在开源创作共享许可协议下,你的投稿已被许可