英语
中文

正翻译步骤 3

步骤 3
This step is for removing the brake drum and the wheel bearing together. Use a mallet and a flat head screwdriver to make a small indentation along the edge of the wheel bearing dust cap. Pry the dust cap out of the brake drum with the flat head screwdriver.
  • This step is for removing the brake drum and the wheel bearing together.

  • Use a mallet and a flat head screwdriver to make a small indentation along the edge of the wheel bearing dust cap.

  • Pry the dust cap out of the brake drum with the flat head screwdriver.

  • Remove the 29 mm rear hub bolt nut from the brake drum. This will require either a breaker bar or an impact wrench.

  • This nut is torqued to 175 ft-lbs, and should not be removed more than four times. Use a permanent marker to make a mark on the nut each time it is removed.

在此插入翻译

在此插入翻译

在此插入翻译

在此插入翻译

在此插入翻译

在开源创作共享许可协议下,你的投稿已被许可