注:你正在为你刚才查阅的指南编辑前提条件。你所做的任何更改将影响包括此步骤的3本指南。
正翻译步骤 6
步骤 6


-
Pull the battery out of the rear case.
-
Adhere the battery, disconnect it, and continue reassembling your device.
[* black] Pull the battery out of the rear case. |
[* icon_note] If your replacement battery came in a plastic sleeve, remove the sleeve before installation by pulling it away from the ribbon cable. |
[* icon_reminder] If there's any alcohol solution remaining in the phone, carefully wipe it off or allow it to air dry before installing your new battery. |
[* icon_reminder] Before you adhere the replacement battery, temporarily reconnect the battery connector to the logic board socket. This ensures that the battery is properly aligned in its recess. |
[* black] Adhere the battery, disconnect it, and continue reassembling your device. |
[* icon_reminder] If your new battery doesn’t have adhesive preinstalled, refer to [guide|107792|this guide] to replace the adhesive strips. |
[* icon_reminder] Perform a [guide|44496|hard reset] after reassembly. This can prevent several issues and simplify troubleshooting. |