跳转到主内容

注:你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的8指南

英语
中文

正翻译步骤 5

步骤 5
Push with your fingers on the rear panel behind the putty knife to minimize bending. Slowly flex the putty knife, as shown in the picture, to ensure that most of the metal tabs on this side of the iPod are disengaged.
  • Push with your fingers on the rear panel behind the putty knife to minimize bending. Slowly flex the putty knife, as shown in the picture, to ensure that most of the metal tabs on this side of the iPod are disengaged.

  • The theory behind this method is, rather than attempting to not bend the rear panel at all, to bend it in a favorable manner that allows you to easily restore it later. Therefore, any bend in the sides of the rear panel should be drawing the lip of the rear panel away from the iPod, rather than pushing out on the curved surface. This method also disengages as many of the side clips as possible.

用手指推在油灰刀后面的后面板上,以减少弯曲。 缓慢地弯曲油灰刀,如图所示,以确保iPod的这一侧的大部分金属片脱开。

这种方法背后的理论是,而不是试图根本不弯曲后面板,以有利的方式弯曲,允许您稍后恢复。 因此,后面板侧面的任何一个弯曲部分都应该将后面板的唇缘从iPod上拉出来,而不是在曲面上推出。 该方法也使尽可能多的侧夹脱离。

在开源创作共享许可协议下,你的投稿已被许可