修复你的物品

维修的权力

商店

注：你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的7指南。

返回指南
英语
中文
上一步 下一步

正翻译步骤 4

步骤 4
Remove the following six screws securing the logic board assembly to the upper case.

  • Remove the following six screws securing the logic board assembly to the upper case.

  • One 3.8 mm T5 Torx screw

  • Two 5.7 mm T5 Torx screws

  • One 5.6 mm T5 Torx screw (this one is silver and has a taller head than the others)

  • One 2.6 mm T5 Torx screw

  • One 3.2 mm T5 Torx screw

  • On reassembly, start all six screws but do not tighten any of them. Move the logic board around until all of the screws are centered in their holes and the ports are lined up with their openings in the side of the upper case. Then tighten all of the screws.

拆掉下列6颗固定主板的螺丝。

一颗3.8mm T5 内梅花头螺丝。

两颗5.7mm T5 内梅花头螺丝。

一颗5.6mm T5 内梅花头螺丝。

一颗2.6mm T5 内梅花头螺丝。

一颗3.2mm T5 内梅花头螺丝。

若要重新组装，先拧上这6颗螺丝，但不要把它们拧紧。移动主板让所有螺丝都正对螺丝口，并且保证所有侧边接口都与机身对应开口对齐。然后再拧紧螺丝。

在开源创作共享许可协议下，你的投稿已被许可。