跳转到主内容

注:你正在为你刚才查阅的指南编辑前提条件。你所做的任何更改将影响包括此步骤的22本指南

英语
中文

正翻译步骤 4

步骤 4
Disconnect the digitizer cable by prying it straight up from its socket on the logic board. When reconnecting the digitizer cable, do not press the center of the connector. Press one end of the connector, then press the opposite end. Pressing in the center of the connector can bend the component and cause digitizer damage.
  • Disconnect the digitizer cable by prying it straight up from its socket on the logic board.

  • When reconnecting the digitizer cable, do not press the center of the connector. Press one end of the connector, then press the opposite end. Pressing in the center of the connector can bend the component and cause digitizer damage.

使用撬棒的平头或指甲断开传感器排线接口, 与主板分离。

重新组装传感器排线时, 请注意不要按压传感器中间的地方。正确应该是先按压一边, 之后再按压另一边, 因为若按压中间的地方, 可能会使零件变形, 造成传感器损坏。

[* black] Use the flat end of a spudger, or a fingernail, to disconnectDisconnect the digitizer cable by prying it straight up from its socket on the logic board.
[* icon_remindericon_caution] When reconnecting the digitizer cable, '''do not press the center of the connector'''. Press one end of the connector, then press the opposite end. Pressing in the center of the connector can bend the component and cause digitizer damage.
[* black] Use the flat end of a spudger, or a fingernail, to disconnectDisconnect the digitizer cable by prying it straight up from its socket on the logic board.
[* icon_remindericon_caution] When reconnecting the digitizer cable, '''do not press the center of the connector'''. Press one end of the connector, then press the opposite end. Pressing in the center of the connector can bend the component and cause digitizer damage.

在开源创作共享许可协议下,你的投稿已被许可