翻译步骤＃4 - Panasonic Lumix DMC-FZ1000 Motherboard Replacement - iFixit

注：你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的2指南。

英语

中文

上一步下一步

正翻译步骤 4

步骤 4

Do not yank off the back plate. If you do, you will tear the electronic ribbons attached to the inside of the camera and the back plate.

Gently lift up the back plate, being careful not to damage any ribbons.

Do not yank out the electronic ribbons attached to the motherboard and the back plate, or you may damage them. To properly detach these ZIF connector ribbons, see this technique on disconnecting ZIF connectors.

Do not yank off the back plate. If you do, you will tear the electronic ribbons attached to the inside of the camera and the back plate.
Gently lift up the back plate, being careful not to damage any ribbons.
Do not yank out the electronic ribbons attached to the motherboard and the back plate, or you may damage them. To properly detach these ZIF connector ribbons, see this technique on disconnecting ZIF connectors.
Pull to disconnect from the motherboard the two ZIF connector ribbons attached to the back plate.
Set aside the back plate.

在开源创作共享许可协议下，你的投稿已被许可。