Skip to main content

注:你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的2指南

英语
德语

正翻译步骤 9

Step 9
Locate the connector which holds the flat cable to the main circuit board. Unlock the connector by gently pulling  up its black piece from the side the flat cable comes into it. Pull the flat cable from the connector and you'll have completely removed the back casing from the camera. Note I taped each of the screws to their original places on the removed back casing, so I don't loose or mix any of them.
Remove flat cable linking the camera's body to the back casing
  • Locate the connector which holds the flat cable to the main circuit board. Unlock the connector by gently pulling up its black piece from the side the flat cable comes into it.

  • Pull the flat cable from the connector and you'll have completely removed the back casing from the camera.

  • Note I taped each of the screws to their original places on the removed back casing, so I don't loose or mix any of them.

在此插入翻译

在此插入翻译

在此插入翻译

在开源创作共享许可协议下,你的投稿已被许可