修复你的物品 维修的权力 商店

注：你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的2指南。

返回指南
英语
中文
上一步 下一步

正翻译步骤 2

步骤 2
Gather the ends of all three adhesive strips in your hand.

  • Gather the ends of all three adhesive strips in your hand.

  • Try to keep the strips flat and unwrinkled during this procedure; wrinkled strips will stick together and break instead of pulling out cleanly.

  • If any of the adhesive strips broke off underneath the battery and could not be retrieved, apply a few drops of high concentration (over 90%) isopropyl alcohol under the edge of the battery in the area of the broken adhesive strip(s).

  • Wait about one minute for the alcohol solution to weaken the adhesive. Use the flat end of a spudger to gently lift the battery.

  • Don't try to forcefully lever the battery out. If needed, apply a few more drops of alcohol to further weaken the adhesive. Never deform or puncture the battery with your pry tool.

  • Do not insert the spudger in the area between the volume down (-) button and the top edge of the battery, or you may damage the volume control cable lying underneath. Do not pry against the logic board or you may damage the phone.

捏住胶带的边缘, 轻缓地向屏幕底部用力拉出。

在撕的过程, 记得保持胶带平整, 不要让胶带起皱。起皱后的胶带会黏在一起, 或造成在拉扯中造成断裂。

如果电池下方的任何胶带断裂且无法挽救，请在电池边缘下方的断裂胶带区域滴几滴高浓度（超过 90%）的异丙醇。

等待大约一分钟，让酒精溶液削弱粘合剂。 使用撬棒扁平的一端轻轻提起电池。

不要尝试用力撬出电池。 如果需要，再滴几滴酒精以进一步削弱粘合剂。 切勿用撬具使电池变形或刺破电池。

不要将撬棒插入音量减小 (-) 按钮和电池顶部边缘之间的区域，否则可能会损坏下方的音量控制电缆。 也不要去撬逻辑板，否则可能会损坏手机。

在开源创作共享许可协议下，你的投稿已被许可。