Skip to main content

注:你正在为你刚才查阅的指南编辑前提条件。你所做的任何更改将影响包括此步骤的23本指南

英语
中文

正翻译步骤 1

Step 1
Remove two Phillips screws securing the battery connector bracket to the logic board, of the following lengths:
  • Remove two Phillips screws securing the battery connector bracket to the logic board, of the following lengths:

  • One 2.9 mm screw

  • One 2.3 mm screw

  • Throughout this guide, keep careful track of your screws so that each one goes back where it came from during reassembly. Installing a screw in the wrong place can cause permanent damage.

卸下电池排线固定架上的2颗Phillips #00 螺丝。

1颗2.9 mm螺丝

1颗2.3 mm螺丝

[* black] Remove the following Phillipstwo Phillips screws securing the battery connector bracket to the logic boardboard, of the following lengths:
[* black] Remove the following Phillipstwo Phillips screws securing the battery connector bracket to the logic boardboard, of the following lengths:
[* red] One 2.9 mm screw
[* orange] One 2.3 mm screw
[* icon_reminder] Throughout this guide, [product|IF145-167-4|keep careful track of your screws|new_window=true] so that each one goes back where it came from during reassembly. Installing a screw in the wrong place can cause permanent damage.

在开源创作共享许可协议下,你的投稿已被许可