跳转到主内容

注:你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的2指南

英语
中文

正翻译步骤 6

步骤 6
Your replacement part may or may not come with the front (sensor) bracket. If it does not, you'll need to transfer it to your new cable. Use the tip of a spudger to flip the "lever" of the ZIF connector (left side in first photo) on the hard drive cable. The connector does not come off, see next instruction. Gently pull the yellow sensor bracket cable out of the ZIF connector (to the right, in the second photo).
  • Your replacement part may or may not come with the front (sensor) bracket. If it does not, you'll need to transfer it to your new cable.

  • Use the tip of a spudger to flip the "lever" of the ZIF connector (left side in first photo) on the hard drive cable. The connector does not come off, see next instruction.

  • Gently pull the yellow sensor bracket cable out of the ZIF connector (to the right, in the second photo).

  • Use the flat end of a spudger to pry the hard drive cable up off the sensor bracket to which it is adhered.

  • Remove the adhesive backing from your new hard drive cable, stick it onto the sensor bracket, and connect the sensor bracket cable.

  • Many fixers cover the length of the thicker cable in the pair with sections of electrical tape on both sides because it can rub the tiny ridges inside the aluminum case causing a short to the case itself or simply breaking the connection.

您的替换支架上可能没有带前感应器支架,如果没有的话,请从旧的上卸下安装到新的上。

使用撬棒的尖端当做杠杆,来将第一张图ZIF连接器翻转。连接器不脱落,请参考下一步骤。

轻轻地将黄色传感器支架电缆拉出ZIF连接器(第二张图片中的右侧)。

使用撬棒的平头将硬盘驱动器电缆从其所粘附的传感器支架上撬起。

从新的硬盘驱动器电缆上取下粘合剂背衬,将其粘在传感器支架上,然后连接传感器支架电缆。

许多固定器覆盖了两侧较厚的电缆的长度,因为它可以摩擦铝壳内部,导致接触机壳短路或者简单地断开连接。

在开源创作共享许可协议下,你的投稿已被许可