跳转到主内容
英语
西班牙语

正翻译步骤 11

步骤 11
Remove the card and again slide it under the top edge of the battery, near the center. Be extremely careful to slide the card over the front-facing camera and headphone jack cables to avoid cutting them. Slide the card in as far as it will go, breaking through as much of the adhesive as you can.
  • Remove the card and again slide it under the top edge of the battery, near the center.

  • Be extremely careful to slide the card over the front-facing camera and headphone jack cables to avoid cutting them.

  • Slide the card in as far as it will go, breaking through as much of the adhesive as you can.

  • Lift up on the card to pry the second battery cell up from the rear case.

  • If there is significant resistance from the battery when you try to pry it up, reheat the adhesive with an iOpener and repeat the previous 3 steps to break apart the adhesive as necessary.

Quita la tarjeta y deslízala nuevamente por debajo del borde superior de la batería, cerca del centro.

Ten mucho cuidado al deslizar la tarjeta sobre la cámara frontal y los cables de los auriculares para evitar cortarlos.

Desliza la tarjeta hasta el tope, rompiendo la mayor cantidad de adhesivo que pueda.

Levanta la tarjeta para levantar la segunda celda de la batería de la carcasa trasera.

Si hay una resistencia significativa de la batería cuando intentas levantarla, vuelve a calentar el adhesivo con un iOpener y repite los 3 pasos anteriores para separar el adhesivo según sea necesario.

在开源创作共享许可协议下,你的投稿已被许可