Skip to main content

注:你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的6指南

英语
中文

正翻译步骤 2

Step 2
Reorient the camera so it is upright and you are looking at the back screen. Remove the rubber covers in the upper and lower right side corners. Insert spudger in between the camera case and the rubber cover and push them out of their sockets. Grab the rubbers with the tweezers and set them aside. Remove both of the 4.3 mm silver screws revealed.
  • Reorient the camera so it is upright and you are looking at the back screen.

  • Remove the rubber covers in the upper and lower right side corners. Insert spudger in between the camera case and the rubber cover and push them out of their sockets. Grab the rubbers with the tweezers and set them aside. Remove both of the 4.3 mm silver screws revealed.

  • Remove the 4.3 mm silver screw in the lower left corner which resides under the sliding battery cover.

  • When removing the screw in the lower left corner, you may need to gently pry open the casing to dislodge the screw.

在此插入翻译

在此插入翻译

在此插入翻译

在此插入翻译

在开源创作共享许可协议下,你的投稿已被许可