跳转到主内容
英语
中文

正翻译步骤 4

步骤 4
Next carefully remove the protective plastic from BOTH sides of your replacement glass.  It's easy to forget the backside. I almost stuck the plastic to my phone. Doing so would have let my new glass come right off. After peeling the plastic off, gently grip the glass with the tweezers or small suction gripping tool and place inside the camera dome. Firmly press into place making sure the edge is flush if not slightly lower than the edge of the dome. I wiped my glass clean and let the warm iOpener sit on top to warm the glue.  I have no idea if this resulted in a firmer grip after cooling, but it seemed to have made the glass more level.
The Eagle has Landed
  • Next carefully remove the protective plastic from BOTH sides of your replacement glass. It's easy to forget the backside. I almost stuck the plastic to my phone. Doing so would have let my new glass come right off.

  • After peeling the plastic off, gently grip the glass with the tweezers or small suction gripping tool and place inside the camera dome. Firmly press into place making sure the edge is flush if not slightly lower than the edge of the dome.

  • I wiped my glass clean and let the warm iOpener sit on top to warm the glue. I have no idea if this resulted in a firmer grip after cooling, but it seemed to have made the glass more level.

  • So comes the end of my first phone repair and thus this tutorial. I hope I made someone a little less trepidatious about doing this repair themselves!

小心移除新玻璃片上两侧的保护膜。

轻轻地将玻璃用镊子将其放置到位。然后用力按压使其固定至水平。

将玻璃擦干净,再次用iOpener放置在上面加热了一下。不知道冷却后会不会粘得更牢,但似乎更平了。

作者:以上就是我第一次修手机的全过程啦,然后写下了这篇教程。我希望我能够帮助那些出现和我一样问题的人,不需要因此忧虑并且能自行解决!自己动手棒棒哒!

在开源创作共享许可协议下,你的投稿已被许可